Home › Drivetrain › U340E (AUTOMATIC TRANSMISSION / TRANSAXLE) › DIFFERENTIAL CASE
RM19S0E _52 Drivetrain _051465 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0248169 DIFFERENTIAL CASE G

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  INSPECTION  


PROCEDURE

Hide 1.INSPECT DIFFERENTIAL SIDE GEAR BACKLASH

a.
C081322

Using a dial indicator, measure the front differential side gear backlash while holding 1 pinion gear toward the case.

Standard backlash:

0.05 to 0.20 mm (0.00197 to 0.00787 in.)


If the backlash is outside the specifications, install the correct front differential side gear thrust washer to the front differential side gear.


b.

Referring to the table below, select front differential side gear thrust washers which will ensure that the backlash is within the specifications for both sides.

Thrust Washer Thickness:
Part No. Thickness
mm (in.)
41361-17010 0.95 (0.0374)
41361-17020 1.00 (0.0394)
41361-17030 1.05 (0.0413)
41361-17040 1.10 (0.0433)
41361-17050 1.15 (0.0453)
41361-17060 1.20 (0.0472)


If the backlash is not within the specifications, install a front differential side gear thrust washer of a different thickness.