41311E
1.REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING
Using SST, remove the front differential case front tapered roller bearing inner race from the differential case.
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case front tapered roller bearing outer race from the transaxle housing.
| *a | Hold |
| *b | Turn |
41311F
2.REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING
Using SST, remove the front differential case rear tapered roller bearing inner race from the differential case.
| *a | Hold |
| *b | Turn |
Using SST, remove the front differential case rear tapered roller bearing outer race and the front differential rear case shim from the transaxle case.
| *a | Hold |
| *b | Turn |
41221
3.REMOVE FRONT DIFFERENTIAL RING GEAR
Place matchmarks on the front differential ring gear and the differential case.
| *a | Matchmark |
Using SST and a hammer, release the ring gear lock plate.
Remove the 8 bolts and the 4 ring gear lock plates.
Using a plastic hammer, remove the front differential ring gear from the differential case.
41342A
4.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a punch and hammer, release the staked part of the differential case hole.
Using a pin punch 5 mm and hammer, remove the front differential pinion shaft straight pin from the differential case.
41342F
5.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the differential case.
41039A
6.REMOVE DIFFERENTIAL GEAR KIT
Remove the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers from the differential case.