Shifting from 1st to 4th is performed in combination with the ON and OFF operations of shift solenoid valves S1 and S2 which are controlled by the ECM. If an open or short circuit occurs in either of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valve to allow the vehicle to be driven smoothly.
(If an open or short circuit occurs, the ECM stops sending current to the affected circuit.)
Fail-safe function (See page Drivetrain>U441E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>FAIL-SAFE CHART).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0976 | ECM detects short in solenoid valve S2 circuit 4 times when solenoid valve S2 is operated (1 trip detection logic). | ·
Wire harness or connector ·
Transmission wire ·
Shift solenoid valve S2 ·
ECM |
| P0977 | ECM detects open in solenoid valve S2 circuit 4 times when solenoid valve S2 is not operated (1 trip detection logic). | ·
Wire harness or connector ·
Transmission wire ·
Shift solenoid valve S2 ·
ECM |
The ECM commands gear shifts by turning the shift solenoid valves ON/OFF. When there is an open or short circuit in the shift solenoid valve S2 circuit, the ECM detects the problem and the MIL comes on. Illuminating the MIL, the ECM performs the fail-safe and turns the other functioning shift solenoid valve ON/OFF.
(If an open or short circuit occurs, the ECM stops sending current to the affected circuit.)
Shift solenoid valve S2 is turned on/off normally when the shift lever is in D:
| Gearshift controlled by ECM | 1st | 2nd | 3rd | 4th |
| Shift solenoid valve S2 | ON | OFF | OFF | ON |
Disconnect the transmission wire connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 10 (S2) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *a | Component without harness connected
(Transmission Wire) |
OK
NG
Connect the transmission wire connector to the transaxle.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B84-78 (S2) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *a | Front view of wire harness connector
(to ECM) |
OK
NG
OK
NG