Home › Drivetrain › U441E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM19S0E _52 Drivetrain _051466 U441E AUTOMATIC TRANSMISSION / TRANSAXLE _0248173 PARK / NEUTRAL POSITION SWITCH A

U441E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 51442C 1.REMOVE ENGINE UNDER COVER LH (for Plastic Type)

Hide 51405A 2.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Hide 33820B 3.SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

C107765

a.

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


b.

Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 84540 4.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Disconnect the connector from the park/neutral position switch assembly.


b.
C107764

Remove the nut, washer and the control shaft lever.


c.
C244577

Pry out the lock plate and remove the nut, lock plate and washer.


d.
C107763

Remove the 2 bolts and pull out the park/neutral position switch assembly from the automatic transaxle assembly.