35410
1.INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Coat a new No. 1 governor apply gasket with Toyota Genuine ATF Type T-IV, and install it to the transaxle case.
Connect the manual valve control rod to the manual valve lever.
Temporarily install the transmission valve body assembly with the 14 bolts.
| Bolt | Bolt Length |
|---|---|
| A | 20 mm (0.787 in.) |
| B | 28 mm (1.102 in.) |
| C | 49 mm (1.929 in.) |
| D | 36 mm (1.417 in.) |
| E | 40 mm (1.575 in.) |
Tighten the 14 bolts.
82125J
2.INSTALL TRANSMISSION WIRE
Engage the clamp and instal the transmission wire.
Connect the 5 connectors to the transmission valve body assembly.
35330
3.INSTALL VALVE BODY OIL STRAINER ASSEMBLY
Coat a new oil strainer gasket with Toyota Genuine ATF Type T-IV and install it to the valve body oil strainer assembly.
Install the valve body oil strainer assembly with the 3 bolts.
35106D
4.INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
Install the 2 oil cleaner magnets to the automatic transaxle oil pan sub-assembly.
Install the automatic transaxle oil pan sub-assembly and a new automatic transaxle oil pan gasket with the 18 bolts.
5.ADD AUTOMATIC TRANSAXLE FLUID
| Classification | Capacity | |
|---|---|---|
| Toyota Genuine ATF T-IV | Dry fill | 5.6 liters (5.9 US qts, 4.9 Imp. qts) |
| Drain and refill | 2.5 liters (2.6 US qts, 2.2 Imp. qts) | |
6.INSPECT AUTOMATIC TRANSAXLE FLUID
7.INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK
51442C
8.INSTALL ENGINE UNDER COVER LH (for Plastic Type)
51405A
9.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)