Home › Drivetrain › U441E (AUTOMATIC TRANSMISSION / TRANSAXLE) › VALVE BODY ASSEMBLY
RM19S0E _52 Drivetrain _051466 U441E AUTOMATIC TRANSMISSION / TRANSAXLE _0248175 VALVE BODY ASSEMBLY A

U441E AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  REMOVAL  


PROCEDURE

Hide 51442C 1.REMOVE ENGINE UNDER COVER LH (for Plastic Type)

Hide 51405A 2.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Hide 3.DRAIN AUTOMATIC TRANSAXLE FLUID

a.

Remove the drain plug and gasket, and drain ATF.


b.

Install a new gasket and the drain plug.

Torque:
17 N*m (175 kgf*cm, 13 ft.*lbf)


Hide 35106D 4.REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C203891

a.

Remove the 18 bolts, automatic transaxle oil pan sub-assembly and the automatic transaxle oil pan gasket.

NOTICE:

Some fluid will remain in the automatic transaxle oil pan sub-assembly. Remove all the oil pan bolts, and carefully remove the automatic transaxle oil pan sub-assembly.



b.
U158258

Remove the 2 oil cleaner magnets from the automatic transaxle oil pan sub-assembly.


c.
AT00103

Examine the particles in the automatic transaxle oil pan sub-assembly.

i.

Collect any steel chips using the removed oil cleaner magnets.

Carefully inspect the foreign matter and particles in the automatic transaxle oil pan sub-assembly and on the oil cleaner magnets to guess at the type of wear which might be found in the automatic transaxle.

Steel (magnetic): bearing, gear and clutch plate wear

Brass (non-magnetic): bearing wear



Hide 35330 5.REMOVE VALVE BODY OIL STRAINER ASSEMBLY

C203892

a.

Remove the 3 bolts and the valve body oil strainer assembly.

NOTICE:

Perform the operation carefully as some fluid will come out from the valve body oil strainer assembly.



b.
U158256

Remove the oil strainer gasket from the valve body oil strainer assembly.


Hide 82125J 6.SEPARATE TRANSMISSION WIRE

a.
C203893

Disconnect the 5 connectors from the transmission valve body assembly.


b.

Disengage the clamp and separate the transmission wire.


Hide 35410 7.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.
C203894

Remove the 14 bolts.


b.
U158257

Disconnect the manual valve control rod from the manual valve lever, then remove the transmission valve body assembly.


c.
U158260

Remove the No. 1 governor apply gasket.