Home › Drivetrain › U441E (AUTOMATIC TRANSMISSION / TRANSAXLE) › OIL PUMP
RM19S0E _52 Drivetrain _051466 U441E AUTOMATIC TRANSMISSION / TRANSAXLE _0248180 OIL PUMP G

U441E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 35370 1.INSPECT STATOR SHAFT ASSEMBLY

C059806

a.

Using a caliper gauge, measure the inside diameter of the stator shaft bush.

Standard inside diameter:

18.424 to 18.449 mm (0.725 to 0.726 in.)


Maximum inside diameter:

18.449 mm (0.726 in.)


If the inside diameter is greater than the maximum, replace the stator shaft assembly.


b.
C059990

Install the input shaft assembly onto the stator shaft assembly, and check that the input shaft assembly turns smoothly.


Hide 35301 2.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

C081414

a.

Using a caliper gauge, measure the inside diameter of the front oil pump body bush.

Standard inside diameter:

38.113 to 38.138 mm (1.5005 to 1.5015 in.)


Maximum inside diameter:

38.138 mm (1.5015 in.)


If the inside diameter is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.


Hide 3.INSPECT OIL PUMP GEAR CLEARANCE

a.
C059809

Check the tip clearance.

Using a feeler gauge, measure the clearance between the tips of the front oil pump driven gear teeth and the front oil pump drive gear teeth.

Standard tip clearance:

0.07 to 0.15 mm (0.00276 to 0.00591 in.)


Maximum tip clearance:

0.15 mm (0.00591 in.)


If the tip clearance is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.


b.
C059810

Check the body clearance.

Using a feeler gauge, measure the clearance between the front oil pump driven gear and front oil pump body.

Standard body clearance:

0.10 to 0.17 mm (0.00394 to 0.00669 in.)


Maximum body clearance:

0.17 mm (0.00669 in.)


If the body clearance is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.


c.
C059811

Check the side clearance.

Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

Standard side clearance:

0.02 to 0.05 mm (0.000787 to 0.00197 in.)


Maximum side clearance:

0.05 mm (0.00197 in.)


If the side clearance is greater than the maximum, replace the front oil pump drive gear, front oil pump driven gear and the front oil pump body.