41211B
1.REMOVE FRONT DRIVE PINION REAR TAPERED ROLLER BEARING
Using SST and a press, remove the front drive pinion rear tapered roller bearing (inner race) and the counter driven gear from the differential drive pinion.
Using SST, remove the front drive pinion rear tapered roller bearing (outer race) and the drive pinion washer from the transaxle case.
41211A
2.REMOVE FRONT DRIVE PINION FRONT TAPERED ROLLER BEARING
Using SST and a press, remove the front drive pinion front tapered roller bearing (inner race) from the differential drive pinion.
Using SST, remove the front drive pinion front tapered roller bearing (outer race) from the transaxle housing.
41211E
3.REMOVE DIFFERENTIAL DRIVE PINION PLUG
Using an extension bar and a hammer, remove the differential drive pinion plug.
41311E
4.REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING
Using SST, remove the front differential case front tapered roller bearing (inner race) from the front differential case.
Using SST, remove the front differential case front tapered roller bearing (outer race) from the transaxle housing.
33481X
5.REMOVE SPEEDOMETER DRIVE GEAR (w/o ABS)
Remove the speedometer drive gear from the front differential case.
41311F
6.REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING
Using SST, remove the front differential case rear tapered roller bearing (inner race) from the front differential case.
Using SST, remove the front differential case rear tapered roller bearing (outer race) and the front differential case rear plate washer from the transaxle case.
41221
7.REMOVE FRONT DIFFERENTIAL RING GEAR
Place matchmarks on the front differential ring gear and the front differential case.
| *a | Matchmark |
Remove the 8 bolts.
Using a plastic hammer, remove the front differential ring gear from the front differential case.
41342A
8.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using a punch and hammer, loosen the staked part of the front differential case.
Using a pin punch 3 mm and hammer, remove the front differential pinion shaft straight pin from the front differential case.
41342F
9.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the front differential case.
41039A
10.REMOVE DIFFERENTIAL GEAR KIT
Remove the differential gear kit (2 front differential pinions and 2 front differential side gears), 2 front differential side gear thrust washers and the 2 front differential pinion thrust washers from the front differential case.