Home › Drivetrain › CLUTCH › CLUTCH SYSTEM › from 2014.07
RM19S0E _52 Drivetrain _051467 CLUTCH _0248185 CLUTCH SYSTEM N

CLUTCH  CLUTCH SYSTEM  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

·

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.



PROCEDURE

Hide 1.REMOVE CENTER COWL TOP VENTILATOR LOUVER (for RHD)

Hide 2.FILL RESERVOIR WITH BRAKE FLUID

Hide 3.BLEED CLUTCH LINE

HINT:

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.


a.
C235122E03
0.615,0.927 0.813,1.094 0.198,0.167 10 true *1 1,0.677 1.208,0.844 0.208,0.167 10 true *2

Remove the release cylinder bleeder plug cap.

Text in Illustration
*1 Release Cylinder Bleeder Plug Cap
*2 Release Cylinder Bleeder Plug


b.

Connect a vinyl tube to the release cylinder bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.


d.

When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.


e.

Repeat both of the previous 2 steps 6 times.


f.

Tighten the release cylinder bleeder plug.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


g.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



h.

Install the release cylinder bleeder plug cap.


i.

Check that all the air has been bled from the clutch line.


Hide 4.INSPECT FOR BRAKE FLUID LEAK

Hide 6.INSTALL CENTER COWL TOP VENTILATOR LOUVER (for RHD)