31470
1.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
Install the clutch release cylinder assembly with the 2 bolts.
31482
2.CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench (10 mm), connect the clutch release cylinder to flexible hose tube to the clutch release cylinder assembly.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.FILL RESERVOIR WITH BRAKE FLUID
4.BLEED CLUTCH LINE
5.INSPECT FOR BRAKE FLUID LEAK
6.INSPECT BRAKE FLUID LEVEL