Home › Drivetrain › CLUTCH › CLUTCH UNIT
RM19S0E _52 Drivetrain _051467 CLUTCH _0248191 CLUTCH UNIT G

CLUTCH  CLUTCH UNIT  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

a.
C213083

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If necessary, replace the clutch disc assembly.


b.
C235153

Install the clutch disc assembly to the manual transaxle assembly.

NOTICE:

Insert the clutch disc assembly in the correct direction.



c.

Using a dial indicator with a roller instrument, measure the clutch disc assembly runout.

Maximum runout:

0.8 mm (0.0315 in.)


If necessary, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

a.
C235160E01
2.052,0.708 2.177,0.865 0.125,0.156 10 false A 2.781,0.448 2.938,0.635 0.156,0.188 10 false B

Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

Maximum:
A (Depth):

0.5 mm (0.0197 in.)

B (Width):

6.0 mm (0.236 in.)


If necessary, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

a.
C235154

Using a dial indicator, measure the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.00394 in.)


If necessary, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

a.
C127507

Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.


b.

Inspect the clutch release bearing assembly for damage and wear.

If necessary, replace the clutch release bearing assembly.