Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH
RM19S0E _52 Drivetrain _051467 CLUTCH _0248192 CLUTCH PEDAL SWITCH G

CLUTCH  CLUTCH PEDAL SWITCH  INSPECTION  


PROCEDURE

Hide 84520 1.INSPECT CLUTCH START SWITCH ASSEMBLY

a.
D011485E34
3.025,2.011 3.412,2.153 0.387,0.142 2.076,1.719 2.227,1.889 0.151,0.170 10 *b 2.234,0.486 2.349,0.640 0.114,0.154 10 1 2.243,0.804 2.367,0.946 0.124,0.142 10 2 1.925,0.645 2.234,0.576 false 1.925,0.778 2.213,0.885 false 0.173,0.149 0.324,0.319 0.151,0.170 10 *a

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Clutch Start Switch Assembly)
*b 7.65 to 8.35 mm (0.301 to 0.329 in.)

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 ON (Pushed in) Below 1Ω
OFF (Released) 10 kΩ or higher


If the resistance is not as specified, replace the clutch start switch assembly.


Hide 84520E 2.INSPECT NO. 2 CLUTCH START SWITCH ASSEMBLY

a.
D011485E34
3.025,2.011 3.412,2.153 0.387,0.142 2.076,1.719 2.227,1.889 0.151,0.170 10 *b 2.234,0.486 2.349,0.640 0.114,0.154 10 1 2.243,0.804 2.367,0.946 0.124,0.142 10 2 1.925,0.645 2.234,0.576 false 1.925,0.778 2.213,0.885 false 0.173,0.149 0.324,0.319 0.151,0.170 10 *a

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(No. 2 Clutch Start Switch Assembly)
*b 7.65 to 8.35 mm (0.301 to 0.329 in.)

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 ON (Pushed in) Below 1Ω
OFF (Released) 10 kΩ or higher


If the resistance is not as specified, replace the No. 2 clutch start switch assembly.