Home › Drivetrain › C54 MANUAL TRANSMISSION / TRANSAXLE › SHIFT AND SELECT LEVER SHAFT
RM19S0E _52 Drivetrain _051468 C54 MANUAL TRANSMISSION / TRANSAXLE _0248203 SHIFT AND SELECT LEVER SHAFT A

C54 MANUAL TRANSMISSION / TRANSAXLE  SHIFT AND SELECT LEVER SHAFT  REASSEMBLY  


PROCEDURE

Hide 33276H 1.INSTALL SELECT SPRING NO. 1 SEAT SHAFT SNAP RING

a.

Coat the shift and select lever shaft with MP grease.


b.
C120738

Install the select spring No. 1 seat shaft snap ring to the shift and select lever shaft using a brass bar and a hammer.


Hide 33256 2.INSTALL SELECT INNER LEVER

C163847

a.

Coat the No. 1 select spring seat with MP grease.


b.

Using a pin punch (5 mm) and a hammer, install the No. 1 select spring seat, compression spring, select inner lever and the slotted spring pin onto the shift and select lever shaft.

Standard drive in depth:

3.0 to 4.0 mm (0.118 to 0.157 in)


NOTICE:

Do not install the No. 1 select spring seat in the wrong direction.



Hide 33251A 3.INSTALL NO. 1 SHIFT LEVER INNER

C163848

a.

Coat the shift inter lock plate and No. 1 shift lever inner with MP grease.


b.

Using a pin punch (5 mm) and a hammer, install the shift inter lock plate, No. 1 shift lever inner and the slotted spring pin onto the shift and select lever shaft.

Standard drive in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)



Hide 33252A 4.INSTALL NO. 2 SHIFT LEVER INNER

C170508

a.

Coat the No. 2 shift lever inner with MP grease.


b.

Using a pin punch (5 mm) and a hammer, install the No. 2 shift lever inner and the slotted spring pin onto the shift and select lever shaft.

Standard drive in depth:

1.0 to 2.0 mm (0.0394 to 0.0787 in.)



Hide 33277 5.INSTALL NO. 2 SELECT SPRING SEAT

C120739

a.

Coat the No. 2 select spring seat with MP grease.


b.

Install the No. 2 select spring seat and the compression spring. Using pliers, install a new E-ring onto the shift and select lever shaft.