41351F
1.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER
Using a micrometer, measure the thickness of the front differential pinion thrust washer.
0.94 mm (0.0370 in.)
If the thickness is less than the minimum, replace the front differential pinion thrust washer.
41342F
2.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Using a micrometer, measure the outer diameter of front No. 1 differential pinion shaft.
16.982 mm (0.669 in.)
If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.