33481
1.REMOVE SPEEDOMETER DRIVE GEAR
Remove the speedometer drive gear from the front differential case.
41221
2.REMOVE FRONT DIFFERENTIAL RING GEAR
Place matchmarks on the front differential ring gear and the front differential case.
| *a | Matchmark |
Remove the 8 bolts.
Using a plastic hammer, remove the front differential ring gear from the front differential case.
3.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH
Fix the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.
0.05 to 0.20 mm (0.00197 to 0.00787 in.)
If the backlash is outside the specifications, replace the front No. 1 differential side gear thrust washers.
41342A
4.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using SST and a hammer, loosen the staked part of the front differential case.
Using a pin punch (3 mm) and a hammer, remove the front differential pinion shaft straight pin from the front differential case.
41342F
5.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the front differential case.
41331F
6.REMOVE FRONT DIFFERENTIAL SIDE GEAR
Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front No. 1 differential side gear thrust washers and the 2 front differential side gears from the front differential case.
Revolving the front differential pinion, remove the 2 front differential pinions and 2 front differential side gears.