Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM19S0E _52 Drivetrain _051469 DRIVE SHAFT / PROPELLER SHAFT _0248206 FRONT DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 43420 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C211744

Check for noticeable looseness when turning the joint up and down, left and right, and in the thrust direction.


b.

Check for cracks, damage and grease leakage on the boot joint.

HINT:

Keep the front drive shaft assembly level while moving it.



c.
C205466E02
1.445,1.547 1.655,1.712 0.210,0.165 10 (A)

Check dimension (A).

Dimension (A):
Drive Shaft Type LH RH
Type A 585.3 mm (1.92 ft.) 827.3 mm (2.71 ft.)
Type B 584.3 mm (1.92 ft.) 826.3 mm (2.71 ft.)


HINT:
C306538E01
0.365,1.05 0.576,1.215 0.210,0.165 10 (A)

Measure the diameter (A) as shown in the illustration to determine the drive shaft type.


Diameter (A):
Drive Shaft Type Diameter
Type A 23.65 mm (0.931 in.)
Type B 24.10 mm (0.949 in.)