Use the same procedure for the RH side as for the LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT AXLE ASSEMBLY
43502G
2.REMOVE FRONT AXLE HUB HOLE SNAP RING
43502C
3.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
47782
4.REMOVE FRONT DISC BRAKE DUST COVER
Remove the disc brake dust cover by tapping the back side with a brass bar and hammer.
43502E
5.REMOVE FRONT AXLE HUB BEARING
Install the removed axle hub bearing inner race onto the outer side of the axle hub bearing.
Using SST and a press, remove the axle hub bearing.