Use the same procedure for the RH side as for the LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
42403
2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
42312E
3.REMOVE REAR AXLE HUB BOLT
Using SST and a screwdriver or the equivalent, remove the axle hub bolt.
| *a | Hold |
| *b | Turn |
42312E
4.INSTALL REAR AXLE HUB BOLT
Install the washer and the nut onto a new axle hub bolt, as shown in the illustration.
| *1 | Washer |
| *2 | Nut |
| *a | Hold |
| *b | Turn |
| Thread Diameter | Thread Pitch |
|---|---|
| 12.0 mm (0.472 in.) | 1.5 mm (0.0591 in.) |
Recommended thickness of the washer is 5 mm (0.197 in.) or more.
Using a screwdriver or the equivalent to hold the axle hub, install the axle hub bolt by tightening the nut.
42403
5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
6.INSTALL REAR WHEEL