Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM19S0E _52 Drivetrain _051470 AXLE AND DIFFERENTIAL _0248212 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side as for the LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 3.INSPECT REAR AXLE HUB BEARING BACKLASH

a.
C121815

Using a dial indicator, check the backlash near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)


If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 4.INSPECT REAR AXLE HUB RUNOUT

a.
C121816

Using a dial indicator, check the runout of the surface of the axle hub.

Maximum:

0.07 mm (0.00276 in.)


If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.


Hide 42403 5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)