Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM(for LH Side)
RM19S0E _53 Suspension _051472 FRONT SUSPENSION _0248216 FRONT LOWER SUSPENSION ARM(for LH Side) A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for LH Side)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 51405A 2.REMOVE ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Hide 48069 3.REMOVE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

C107513

a.

Remove the clip and castle nut.


b.
C172759E05
2.531,0.936 2.853,1.085 0.322,0.149 10 SST 2.503,1.029 2.36,1.273 false

Install SST to the threaded section of the lower ball joint.

SST
09960-20010  (09961-02060)

NOTICE:

Make sure the upper ends of the threaded section of the lower ball joint and SST are aligned.



c.

Using SST, separate the front lower suspension arm sub-assembly LH from the front axle assembly.

U158304E01
4.994,1.988 5.158,2.147 0.164,0.158 10 *a 5.164,2.047 5.469,1.833 false 6.138,0.625 6.363,0.934 0.225,0.309 10 A 6.138,0.982 6.457,1.301 0.319,0.319 10 B 1.403,2.404 1.739,2.588 0.336,0.184 10 SST 1.55,2.376 1.893,2.229 false

Text in Illustration
*a Place the wrench here - -
V100135

Apply grease to the bolt threads and the tip of SST. - -

SST
09960-20010  (09961-02010)

NOTICE:
·

Make sure to tie the string of SST to the vehicle to prevent SST from dropping.

·

Install SST so that A and B are parallel.

·

Be sure to place the wrench on the part indicated in the illustration.

·

Do not damage the lower ball joint dust cover.

·

Do not damage the drive shaft outboard joint boots.

·

Do not damage the front disc brake dust cover.




d.
C107515

Remove the 2 bolts and front lower suspension arm sub-assembly LH.