Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM19S0E _53 Suspension _051472 FRONT SUSPENSION _0248217 FRONT STABILIZER BAR G

FRONT SUSPENSION  FRONT STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY

a.
C066721

As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 0.25 to 0.5 turns per seconds and take the torque reading on the 5th turn.

Torque:
0.05 to 1.96 N*m (0.51 to 19.99 kgf*cm, 0.44 to 17.35 in.*lbf)


c.

Check for any cracks and grease leakage on the ball joint dust cover.