Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM19S0E _53 Suspension _051473 REAR SUSPENSION _0248222 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side as for the LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 58732C 2.REMOVE REAR ABSORBER CAP

Hide 48540 3.REMOVE REAR SHOCK ABSORBER ASSEMBLY

a.

Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.


b.
U134470

Remove the 2 nuts while keeping the piston rod from rotating.


c.

Remove the rear shock absorber cushion retainer and rear suspension support.


d.
C106031

Remove the bolt while keeping the nut from rotating and remove the rear shock absorber assembly.

NOTICE:

Remove the nut from the bolt side because the one on the lower side is a jam nut.



Hide 48752A 4.REMOVE REAR SUSPENSION SUPPORT STOPPER

Hide 48760B 5.REMOVE REAR SUSPENSION SUPPORT ASSEMBLY