Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM19S0E _53 Suspension _051473 REAR SUSPENSION _0248223 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 89516D 3.SEPARATE SKID CONTROL SENSOR WIRE LH (w/ ABS)

a.
C107565

Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire LH connector.

NOTICE:

Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.



b.
C107566

Remove the nut and separate the skid control sensor wire LH.


Hide 89516C 4.SEPARATE SKID CONTROL SENSOR WIRE RH (w/ ABS)

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 47319F 5.SEPARATE REAR FLEXIBLE HOSE LH

a.
C235742

Using a union nut wrench (10 mm), separate the brake tube while holding the rear flexible hose LH with a wrench.


b.

Remove the clip and disconnect the rear flexible hose LH from the rear axle beam assembly.


Hide 47318F 6.SEPARATE REAR FLEXIBLE HOSE RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 42110F 7.LOOSEN REAR AXLE BEAM ASSEMBLY

a.
C112605E15
0.125,0.125 0.344,0.302 0.219,0.177 12 true *a 1.823,0.115 2.052,0.302 0.229,0.188 12 true *b

Loosen the 2 bolts.

Text in Illustration
*a RH Side
*b LH Side

NOTICE:

Do not remove the bolts.



Hide 48540 8.SEPARATE REAR SHOCK ABSORBER ASSEMBLY LH

a.
C106031

Support the rear axle beam assembly using a jack and wooden block as shown in the illustration.


b.

Remove the bolt while keeping the nut from rotating and separate the rear shock absorber assembly LH.

NOTICE:

Remove the nut from the bolt side because the one on the lower side is a jam nut.



Hide 48530 9.SEPARATE REAR SHOCK ABSORBER ASSEMBLY RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 48231B 10.REMOVE REAR COIL SPRING LH

a.

Lower the jack slowly.


b.

Remove the rear coil spring LH, rear coil spring upper insulator LH and rear coil spring lower insulator LH.


Hide 48231A 11.REMOVE REAR COIL SPRING RH

HINT:

Use the same procedure for the RH side as for the LH side.