Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248226 ANTI-LOCK BRAKE SYSTEM U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  TERMINALS OF ECU  


TERMINALS OF ECU


C146351E02
0.109,0.017 0.487,0.222 0.378,0.205 10 *a

Text in Illustration
*a Component without harness connected
(Skid Control ECU (Brake Actuator Assembly))

Terminal No. (Symbol) Terminal Description
1 (GND1) Skid control ECU ground
4 (RL-) Rear wheel speed LH (-) signal input
5 (RL+) Rear wheel speed LH (+) power supply output
6 (FR-) Front wheel speed RH (-) signal input
7 (FR+) Front wheel speed RH (+) power supply output
12 (+BS) Solenoid relay power supply
13 (GND2) Pump motor ground
14 (CANL) CAN communication line L
16 (RR-) Rear wheel speed RH (-) signal input
17 (RR+) Rear wheel speed RH (+) power supply output
18 (FL-) Front wheel speed LH (-) signal input
19 (FL+) Front wheel speed LH (+) power supply output
22 (SP1) Speed signal output for speedometer
24 (+BM) Motor relay power supply
25 (CANH) CAN communication line H
28 (STP) Stop light switch input
34 (IG1) ECU power supply


TERMINAL INSPECTION


a.
U158339E02
1.74,0.146 2.031,0.323 0.292,0.177 10 false A55 0.146,0.156 0.333,0.323 0.188,0.167 10 false *a

Disconnect the connector and measure the voltage or resistance on the wire harness side.

HINT:

Voltage cannot be measured with the connector connected to the brake actuator assembly (skid control ECU) as the connector is watertight.


Text in Illustration
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))

Standard:
Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A55-1 (GND1) - Body ground W-B - Body ground Skid control ECU ground Always Below 1 Ω
A55-12 (+BS) - Body ground W - Body ground Solenoid relay power supply Always 11 to 14 V
A55-13 (GND2) - Body ground W-B - Body ground Pump motor ground Always Below 1 Ω
A55-24 (+BM) - Body ground B - Body ground Motor relay power supply Always 11 to 14 V
A55-25 (CANH) - A55-14 (CANL) G - W CAN bus Ignition switch off 54 to 69 Ω
A55-28 (STP) - Body ground P - Body ground Stop light switch input Stop light switch ON → OFF
(Brake pedal depressed → released)
7.5 to 14 V
→ Below 1.5 V
A55-34 (IG1) - Body ground L - Body ground ECU power supply Ignition switch ON 11 to 14 V