Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR › 2011.08–2017.01
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248230 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Install the speed sensor onto the steering knuckle with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Check that the speed sensor tip and installation portion are free of foreign matter.

·

Install the speed sensor without turning it from its original installation angle.




b.

Install the No. 1 clamp onto the shock absorber with the bolt.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)


c.

Install the No. 2 clamp onto the body with the bolt.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


d.

Engage the 2 clamps onto the body.


e.

Install the No. 3 clamp onto the body.


f.

Connect the speed sensor connector.


g.

Engage the clamp onto the body.


Hide 53876A 2.INSTALL FRONT FENDER LINER

a.

Install the front fender liner with 7 clips, 2 screws and 4 new grommets.


Hide 3.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)