Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248234 YAW RATE AND DECELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89183A 1.INSTALL YAW RATE AND DECELERATION SENSOR

a.

Install the yaw rate and deceleration sensor with the 2 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:

Make sure that the sensor is at the correct angle when installing.



b.

Connect the yaw rate and deceleration sensor connector.


Hide 89187A 2.INSTALL YAW RATE SENSOR PROTECTOR

a.

Install the yaw rate sensor protector with the 2 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


Hide 58910C 3.INSTALL REAR CONSOLE BOX ASSEMBLY