Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248235 VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor) U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)  TERMINALS OF ECU  


TERMINALS OF ECU


C197053E09
0.139,0.087 0.410,0.276 0.272,0.188 10 *a

Text in Illustration
*a Component without harness connected
(Skid Control ECU (Brake Actuator Assembly))

Terminal No. (Symbol) Terminal Description
1 (GND1) Skid control ECU ground
2 (STP) Stop light switch input
4 (RL-) Rear wheel speed LH (-) signal input
5 (RL+) Rear wheel speed LH (+) power supply output
6 (FR-) Front wheel speed RH (-) signal input
7 (FR+) Front wheel speed RH (+) power supply output
11 (SP1) Speed signal output for speedometer
12 (+BS) Solenoid relay power supply
13 (GND2) Pump motor ground
14 (CANL) CAN communication line L
16 (RR-) Rear wheel speed RH (-) signal input
17 (RR+) Rear wheel speed RH (+) power supply output
18 (FL-) Front wheel speed LH (-) signal input
19 (FL+) Front wheel speed LH (+) power supply output
24 (BM) Motor relay power supply
25 (CANH) CAN communication line H
30 (CSW) VSC OFF switch input
34 (IG1) ECU power supply


TERMINAL INSPECTION


a.
U158450E02
0.135,0.146 0.333,0.313 0.198,0.167 10 false *a 1.615,0.177 1.885,0.354 0.271,0.177 10 false A54

Disconnect the connector and measure the voltage or resistance on the wire harness side.

HINT:

Voltage cannot be measured with the connector connected to the brake actuator assembly (skid control ECU) as the connector is watertight.


Text in Illustration
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))

Standard:
Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A54-1 (GND1) - Body ground W-B - Body ground Skid control ECU ground Always Below 1 Ω
A54-2 (STP) - Body ground P - Body ground Stop light switch input Stop light switch ON → OFF
(Brake pedal depressed → released)
7.5 to 14 V
→ Below 1.5 V
A54-12 (+BS) - Body ground W - Body ground Solenoid relay power supply Always 11 to 14 V
A54-13 (GND2) - Body ground W-B - Body ground Pump motor ground Always Below 1 Ω
A54-24 (BM) - Body ground B - Body ground Motor relay power supply Always 11 to 14 V
A54-25 (CANH) - A54-14 (CANL) G - W CAN bus Ignition switch off 54 to 69 Ω
A54-30 (CSW) - Body ground B - Body ground VSC OFF switch input VSC OFF switch held ON → OFF (Not pressed) Below 25 Ω → 10 kΩ or higher
A54-34 (IG1) - Body ground L - Body ground ECU power supply Ignition switch ON 11 to 14 V