Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248235 VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)  C1442  Invalid Data Received from Deceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and deceleration (yaw rate sensor) via the CAN communication system.

DTC No. DTC Detection Condition Trouble Area
C1442 Both of the following is condition is met.
1.

With the IG1 terminal voltage between 9.5 and 17.4 V.

2.

An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.


Yaw rate and deceleration (yaw rate sensor)
C1443 Both of the following is condition is met.
1.

With the IG1 terminal voltage between 9.5 and 17.4 V.

2.

An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more.



CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).


PROCEDURE

1.CHECK DTC

b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.


d.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTCs C1442 and/or C1443 are output A
DTCs C1442 and C1443 are not output B



A

REPLACE YAW RATE AND DECELERATION (YAW RATE SENSOR)

B