Home › Brake › BRAKE SYSTEM (OTHER) › PROPORTIONING VALVE
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248236 PROPORTIONING VALVE A

BRAKE SYSTEM (OTHER)  PROPORTIONING VALVE  INSTALLATION  


PROCEDURE

Hide 47150 1.INSTALL PROPORTIONING VALVE

a.

Install the proportioning valve onto the proportioning valve bracket with the 2 nuts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


b.

Using a union nut wrench 10 mm, install the 3 brake tubes onto the proportioning valve and the brake tube way.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.
C244474E02
1.177,1.823 1.271,1.969 0.094,0.146 10 false 1 1.802,1.958 1.896,2.104 0.094,0.146 10 false 2

Install the proportioning valve bracket with the 2 bolts in the sequence order shown in the illustration.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


d.

Using a union nut wrench 10 mm, install the 6 brake tubes onto the proportioning valve and the brake tube way.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 74411 2.INSTALL BATTERY CARRIER

a.

Install the battery carrier with the 5 bolts.

Torque:
17 N*m (173 kgf*cm, 13 ft.*lbf)


b.

Engage the 6 wire harness clamps and install the wire harness.


Hide 74431 3.INSTALL BATTERY TRAY

Hide 5. FILL RESERVOIR WITH BRAKE FLUID

Hide 47201 6.BLEED MASTER CYLINDER

Hide 8.INSPECT FOR BRAKE FLUID LEAK

Hide 10.INSTALL CENTER COWL TOP VENTILATOR LOUVER

C241408

a.

Engage the 2 claws and 6 guides and install the cowl top ventilator louver center.


b.

Engage the 2 claws and install the washer hose joint.


c.
C241854

Engage the 2 clips and slide the hood to cowl top seal as shown in the illustration.