Home › Brake › BRAKE SYSTEM (OTHER) › PROPORTIONING VALVE
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248236 PROPORTIONING VALVE G

BRAKE SYSTEM (OTHER)  PROPORTIONING VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 47150 1.INSPECT PROPORTIONING VALVE

a.

Remove the bleeder plug from the front brake caliper and rear wheel cylinder.

C244827E01
1.244,1.847 1.544,1.999 0.300,0.152 10 SST 1.208,1.915 0.873,1.915 false 5.654,1.422 5.955,1.574 0.300,0.152 10 SST 6.314,1.487 5.979,1.487 false 6.491,2.28 6.791,2.432 0.300,0.152 10 SST 6.441,2.357 5.634,2.744 false 2.019,2.785 2.320,2.938 0.300,0.152 10 SST 1.983,2.854 1.561,3.1 false


b.

Install SST and then bleed the air.

SST
09709-29018  (09709-00060)


c.

Raise the front brake caliper pressure and inspect the rear wheel cylinder pressure.

Standard Fluid Pressure:
Front Brake Caliper Pressure Rear Wheel Cylinder Pressure
1500 kPa (15.3 kgf/cm2, 218 psi) 1500 kPa (15.3 kgf/cm2, 218 psi)
5000 kPa (51.0 kgf/cm2, 725 psi) 2350 kPa (24.0 kgf/cm2, 341 psi)
8000 kPa (81.6 kgf/cm2, 1160 psi) 3100 kPa (31.6 kgf/cm2, 450 psi)


HINT:

When inspecting the fluid pressure, inspect the left front and right rear together, and the right front and left rear together.

If the rear wheel cylinder pressure is incorrect, replace the proportioning valve.



d.

Remove SST.


e.

Install the bleeder plug onto the front brake caliper and rear wheel cylinder.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


f.

Bleed the brake fluid (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING).


g.

Check the brake fluid leakage.