Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID › from 2014.07
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248237 BRAKE FLUID A

BRAKE SYSTEM (OTHER)  BRAKE FLUID  REPLACEMENT  


CAUTION / NOTICE / HINT

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


HINT:

If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the system.


PROCEDURE

Hide 1.REMOVE CENTER COWL TOP VENTILATOR LOUVER

Hide 2. FILL RESERVOIR WITH BRAKE FLUID

Hide 3.REPLACE BRAKE FLUID

a.
C182332

Connect a vinyl tube to the bleeder plug.


b.

Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed (Step C).


c.

At the point where the fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (Step D).


d.

Repeat Steps C and D until the new brake fluid comes out.


e.

Tighten the bleeder plug.

Torque:
Front Brake : 8.3 N*m (85 kgf*cm, 73 in.*lbf)
Rear Brake : 8.5 N*m (87 kgf*cm, 75 in.*lbf)


f.

Repeat the above procedure to bleed the air out of the brake line for each wheel.


Hide 4.INSPECT FOR BRAKE FLUID LEAK

Hide 6.INSTALL CENTER COWL TOP VENTILATOR LOUVER