Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2011.08–2014.07
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248242 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o VSC)

a.

Install a new O-ring onto the brake master cylinder sub-assembly.


b.

Install the brake master cylinder sub-assembly with the 2 nuts.

Torque:
13 N*m (128 kgf*cm, 9 ft.*lbf)


c.

Using a union nut wrench 10 mm, install the 2 brake tubes onto the brake master cylinder sub-assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the brake fluid level warning switch connector.


Hide 47201 2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ VSC)

a.

Install a new O-ring onto the brake master cylinder sub-assembly.


b.

Install the brake master cylinder sub-assembly with the 2 nuts.

Torque:
13 N*m (128 kgf*cm, 9 ft.*lbf)


c.

Using a union nut wrench 12 mm, install the 2 brake tubes onto the brake master cylinder sub-assembly.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the brake fluid level warning switch connector.


Hide 3.INSTALL CLUTCH RESERVOIR TUBE (for Manual Transaxle)

a.

Connect the clutch reservoir tube with the clip.


Hide 4.BLEED BRAKE LINE

Hide 5.BLEED CLUTCH LINE (for Manual Transaxle)

Hide 6.INSTALL CENTER COWL TOP VENTILATOR LOUVER