Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › from 2014.07
RM19S0E _54 Brake _051476 BRAKE SYSTEM (OTHER) _0248242 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from booster by depressing the brake pedal several times.

Then remove the brake master cylinder from brake booster.


PROCEDURE

Hide 1.REMOVE CENTER COWL TOP VENTILATOR LOUVER

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 3.SEPARATE CLUTCH RESERVOIR TUBE

a.
C235484

Slide the clip and separate the clutch reservoir tube.


Hide 47201 4.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ VSC)

NOTICE:
·

The master cylinder requires careful handling. Do not allow the master cylinder to receive any impact, such as from being dropped. Do not reuse a master cylinder that has been dropped.

·

Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

·

Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder from brake booster.

·

When installing the brake master cylinder sub-assembly onto the brake booster, or when removing the brake master cylinder sub-assembly from the brake booster, make sure that the brake master cylinder sub-assembly is kept horizontal or its tip faces downward (the piston faces upward) to prevent the master cylinder piston from falling off.

·

Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth and then apply an even layer of lithium soap based glycol grease around the circumference (sliding part) of the piston.

·

Do not use any other type of grease or fluid.



a.

Disconnect the brake fluid level warning switch connector.


b.
C235196

Using a union nut wrench 12 mm, separate the 2 brake tubes from the brake master cylinder sub-assembly.


c.
C234721

Remove the bolt.


d.

Disengage the harness clamp and separate the wire harness.


e.

Remove the 2 nuts and the brake master cylinder sub-assembly.


f.

Remove the O-ring from the brake master cylinder sub-assembly.