1.REMOVE CYLINDER BOOT
Using a screwdriver with its tip wrapped in protective tape, remove the set ring and cylinder boot from the disc brake cylinder.
| *1 | Protective Tape |
Be careful not to damage the brake piston or cylinder.
47731
2.REMOVE FRONT DISC BRAKE PISTON
Place a piece of cloth between the piston and disc brake cylinder.
| *1 | Cloth |
Apply compressed air to remove the piston from the disc brake cylinder.
Do not place your fingers in front of the piston when applying compressed air.
Do not spatter the brake fluid.
3.REMOVE PISTON SEAL
Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the disc brake cylinder.
| *1 | Protective Tape |
Do not damage the inner surface or piston seal groove of the cylinder.
31478B
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47547B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG