47313A
1.INSTALL FRONT BRAKE FLEXIBLE HOSE
Install the flexible hose with a new union bolt and a new gasket.
Install the flexible hose lock securely into the lock hole in the disc brake cylinder.
Install the flexible hose and speed sensor with the bolt.
Install the flexible hose and speed sensor without twisting them.
Install the flexible hose with a new clip.
Using a union nut wrench 10 mm, install the brake tube to the flexible hose while holding the flexible hose with a wrench.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.BLEED BRAKE LINE
3.BLEED CLUTCH LINE (for Manual Transaxle)
(See page Drivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING)
4.INSTALL FRONT WHEEL