04495
1.REMOVE REAR BRAKE SHOE KIT
Using SST, separate the shoe return spring from the front brake shoe.
Do not damage the wheel cylinder boot.
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.
Remove the tension spring.
Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.
Using needle-nose pliers, separate the parking brake cable.
47644A
2.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER
Remove the automatic adjust lever tension spring and the automatic adjust lever.
47548R
3.REMOVE REAR DRUM BRAKE BLEEDER PLUG CAP
47547R
4.REMOVE REAR DRUM BRAKE BLEEDER PLUG
47570
5.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY
Using a union nut wrench 10 mm, separate the brake tube from the rear wheel brake cylinder.
Use a container to catch the brake fluid.
Remove the bolt and rear wheel brake cylinder.
04474
6.REMOVE REAR WHEEL CYLINDER KIT
Remove the 2 wheel cylinder boots from the wheel brake cylinder.
| *1 | Wheel Cylinder Boot |
| *2 | Wheel Cylinder Piston |
| *3 | Wheel Cylinder Cup |
| *4 | Compression Spring |
Remove the 2 pistons.
Remove the wheel cylinder cup from each piston.
Remove the compression spring.