Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.08–2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Start the engine.


d.

Turn the tester on.


e.

Enter the following menus: Chassis / EMPS / Data List.


f.

According to the display on the tester, read the Data List.



EMPS
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Meter Vehicle Velocity Vehicle speed from meter/
Min.: 0.0 km/h (0 mph)
Max.: 300.0 km/h (186.4 mph)
0.0 km/h (0 mph) Turn the ignition switch ON and vehicle stopped
No significant fluctuation Vehicle driven at constant speed
Engine Revolution Engine revolution
Min: 0 rpm
Max: 12800 rpm
No significant fluctuation The engine is running at constant speed
Motor Actual Current Current to motor/
Min.: -327.68 A
Max.: 327.67 A
Value changes in proportion to steering effort The engine is running and power steering is in operation
Command Value Current Requested current to motor/
Min.: -327.68 A
Max.: 327.67 A
Value changes in proportion to steering effort The engine is running and power steering is in operation
Thermistor Temperature ECU substrate temperature/
Min.: -50.0°C (-58°F)
Max.: 150.0°C (302°F)
-50.0 to 150.0°C (-58 to 302°F) -
PIG Power Supply Power source voltage to activate motor/
Min.: 0.0000 V
Max.: 20.1531 V
11 to 14 V The engine is running
IG Power Supply ECU power source voltage/
Min.: 0.0000 V
Max.: 20.1531 V
11 to 14 V The engine is running
Steering Wheel Torque Steering wheel torque/
Min.: -327.68 Nm
Max.: 7.00 Nm
Value changes in proportion to steering effort The engine is running and power steering is in operation
Torque Sensor 1 Output Torque sensor 1 output value/
Min.: 0.0000 V
Max.: 4.9725 V
2.3 to 2.7 V The engine is running and steering wheel not turned (without load)
2.5 to 3.8 V The engine is running and steering wheel turned to right with vehicle stopped
1.2 to 2.5 V The engine is running and steering wheel turned to left with vehicle stopped
Torque Sensor 2 Output Torque sensor 2 output value/
Min.: 0.0000 V
Max.: 4.9725 V
2.3 to 2.7 V The engine is running and steering wheel not turned (without load)
1.2 to 2.5 V The engine is running and steering wheel turned to right with vehicle stopped
2.5 to 3.8 V The engine is running and steering wheel turned to left with vehicle stopped
TRQ1 Zero Point Value Zero point value of torque sensor 1/
Min.: 0.0000 V
Max.: 4.9725 V
2.3 to 2.7 V The engine is running and steering wheel not turned (without load)
TRQ2 Zero Point Value Zero point value of torque sensor 2/
Min.: 0.0000 V
Max.: 4.9725 V
2.3 to 2.7 V The engine is running and steering wheel not turned (without load)
Motor Terminal Volt (+) Motor terminal M1 voltage/
Min.: 0.0 V
Max.: 25.5 V
11 to 14 V The engine is running and steering wheel turned to right
6 to 11 V The engine is running and steering wheel turned to left
Motor Terminal Volt (-) Motor terminal M2 voltage/
Min.: 0.0 V
Max.: 25.5 V
6 to 11 V The engine is running and steering wheel turned to right
11 to 14 V The engine is running and steering wheel turned to left
IG ON/OFF Times Number of times of power switch ON/OFF after fail detection/
Min.: 0 times
Max.: 65535 times
- This value indicates the number of times of IG ON/OFF after the latest DTC detection
Motor Overheat Record Continuous overheat prevention control record/
Unrec or Rec
Unrec -
Motor Lo Power Record PIG power source voltage drop record/
Unrec or Rec
Unrec -
Eng Rev Inter Record Status of the Record of Engine Revolution Signal Interrupt/
Unrec or Rec
Unrec -
Spd Sig Invalid Record Vehicle speed signal invalid record/
Unrec or Rec
Unrec -
Battery Voltage Lo Record Battery voltage drop record/
Min.: 0 times
Max.: 65535 times
0 times -
Stop & Start Control Mode Status of stop and start system control mode/
IG/Run/Stopreq/Stop/Restart
IG -
The Number of DTCs Number of detected DTCs when freeze frame data stored/
Min.: 0
Max.: 255
0 to 255 -