Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.08–2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  FAIL-SAFE CHART  


When a problem occurs in the electronic power steering system, the EPS warning light on the combination meter comes on, and the ECU stops the steering power assist, maintains the amount of power assist constant, or reduces the amount of power assist to protect the system.

DTC No. Malfunction Fail-safe
C1511
C1512
C1513
C1514
C1516
C1517
Torque sensor malfunction Power assist stopped or assist force restricted
C1524 Motor malfunction Power assist stopped or assist force restricted
C1531
C1532
Power steering ECU malfunction Power assist stopped or assist force restricted
C1533 Temperature sensor malfunction in power steering ECU Power assist stopped or assist force restricted
C1534 EEPROM abnormal Controlled using current default map
C1535 Steering wheel location data error Power assist stopped or assist force restricted
C1541*1 Vehicle speed signal error Assist force restricted
C1542*1
C1551 IG power source voltage error Power assist stopped or assist force restricted
C1552 PIG power source voltage error Power assist stopped or assist force restricted
C1553 Overvoltage at IG and PIG terminals Power assist stopped or assist force restricted
C1554 Power source relay malfunction Power assist stopped or assist force restricted
C1555 Motor relay malfunction Power assist stopped or assist force restricted
C1581 Assist Map Number Un-Writing Power assist permitted using default value
C1582 Assist Map Number Mismatch Control is performed using the current assist map.
U0100 ECM communication error Assist force restricted
U0129 Skid control ECU communication error Assist force restricted
- Extremely high temperature in ECU Assist force restricted until normal ECU temperature recovers
- Power source voltage drop Assist force suspended until voltage recovers

*1: w/o ABS


HINT:

The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.