Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  FAIL-SAFE CHART  


If a problem occurs in the power steering system, the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.

DTC No. Malfunction Fail-safe
C1511
C1512
C1513
C1514
C1515
C1516
C1517
Torque sensor malfunction Assist force restricted or power assist stopped
C1524 Motor malfunction
C1531
C1532
Power steering ECU assembly malfunction
C1533 Temperature sensor malfunction in power steering ECU assembly
C1534 EEPROM abnormal
C1535 Steering wheel location data error
C1551 IG power source voltage error Power assist stopped
C1552 PIG power source voltage error
C1553 Overvoltage at IG and PIG terminals
C1554 Power source relay malfunction
C1555 Motor relay malfunction
C1581 Assist map not written in power steering ECU assembly Controlled using default map
C1582 Assist map mismatch written in power steering ECU assembly Controlled using current default map
U0100 Lost communication with ECM Assist force restricted
U0129 Lost communication with skid control ECU (brake actuator assembly)

HINT:
·

The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept in either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.

·

If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns normal when the battery voltage recovers.