Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1531  ECU Malfunction  C1532  ECU Malfunction  C1533  ECU Malfunction  C1534  ECU Malfunction  C1535  ECU Malfunction  


DESCRIPTION

The fail-safe function operates to stop power assist when DTCs indicating ECU malfunctions are stored. However, the power assist operation continues when DTC C1533 or C1534 is stored because it indicates an EEPROM error in the ECU.

DTC No. DTC Detection Condition Trouble Area
C1531 ECU internal malfunction (CPU malfunction) Power steering ECU assembly
C1532 ECU internal malfunction (Peripheral circuit malfunction)
C1533 ECU internal malfunction (Substrate temperature sensor malfunction)
C1534 ECU internal malfunction (EEPROM error)
C1535 ECU internal malfunction (Steering wheel location data error)

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CONFIRM DTC
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTCs other than C1531, C1532, C1533, C1534 and C1535 are output A
Other DTC are not output (for LHD) B
Other DTC are not output (for RHD) C



A

B

REPLACE POWER STEERING ECU ASSEMBLY

C

REPLACE POWER STEERING ECU ASSEMBLY