Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.08–2014.07
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM J

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  PS Warning Light Remains ON  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform this troubleshooting procedure when no DTCs are output, including DTCs related to CAN communication system malfunctions.

·

If the customer reports that the steering feels heavy, refer to the "Heavy steering" item in the Problem Symptoms Table.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>PROBLEM SYMPTOMS TABLE



PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY
a.

Perform the Active Test of the combination meter assembly using the GTS.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Body / Combination Meter / Active Test.


v.

According to the display on the GTS, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. EPS EPS warning light OFF/ON Vehicle is stopped and engine is idling



b.

Check the combination meter assembly.

OK:

The EPS warning light turns on or off in accordance with the GTS operation.


Result
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE POWER STEERING ECU ASSEMBLY

C