Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for LHD)
RM19S0E _55 Steering _051481 STEERING COLUMN _0248256 STEERING COLUMN ASSEMBLY(for LHD) G

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for LHD)  INSPECTION  


PROCEDURE

Hide 1.INSPECT PRELOAD

a.
C241873E01
0.374,1.117 0.529,1.302 0.155,0.184 10 *1 0.545,1.212 1.186,1.338 false 0.426,0.73 0.783,0.872 0.357,0.142 10 SST 0.787,0.831 1.761,1.209 false

Secure the steering column assembly in a vise.

Text in Illustration
*1 Wooden Block

NOTICE:

When using a vise, do not overtighten it.



b.

Using SST and a torque wrench, turn the main shaft at a fixed speed of approximately 1 revolution every 4 seconds and measure the preload.

SST
09616-00011  

Torque:
Preload : 1.45 N*m (14.8 kgf*cm, 12.8 in.*lbf)

or less


If the preload is not as specified, replace the steering column assembly with a new one.


Hide 2.INSPECT STEERING LOCK OPERATION

a.

Remove the key and check that the steering lock function is activated.


b.
C233277

Insert the key, turn the ignition switch to ACC and check that the steering lock function has been deactivated.


Hide 45250 3.INSPECT STEERING COLUMN ASSEMBLY

a.
C235885

Check that the 2 bushings are securely installed to the steering column assembly.

If the bushings are deformed, missing or damaged, replace the steering column assembly with a new one.


b.
C234253E01
1.442,0.073 1.599,0.226 0.157,0.153 10 *1 1.049,0.165 1.417,0.165 1.417,0.165 1.045,1.136 false 1.795,0.886 2.021,1.034 0.226,0.149 10 OK 2.72,0.886 2.947,1.034 0.226,0.149 10 NG

Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

Text in Illustration
*1 Capsule

Standard:

Capsules do not overlap the corner parts of the brackets.


NOTICE:
·

If the standard value is not satisfied, replace the steering column assembly with a new one.

·

If the capsules have deformation, damage or misalignment, replace the steering column assembly with a new one.