Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM19S0E _55 Steering _051482 STEERING GEAR / LINKAGE _0248260 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

a.
C132329

Secure the tie rod end sub-assembly LH in a vise.

NOTICE:

Do not overtighten the vise.



b.

Install the nut onto the stud bolt.


c.

Flip the ball joint back and forth 5 times.


d.

Set a torque wrench to the nut, turn the ball joint continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.

Standard turning torque:

0.29 to 1.96 N*m (2.96 to 20.0 kgf*cm, 2.57 to 17.3 in.*lbf)


HINT:

If turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.



Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

a.
C107934E02
1.001,0.544 1.291,0.848 0.290,0.304 10 SST 2.779,1.174 2.956,1.347 0.177,0.174 10 *1 2.747,1.262 2.151,1.108 false 1.647,0.792 1.362,0.635 false

Using SST, secure the steering gear in a vise.

Text in Illustration
*1 Protective Tape

SST
09612-00012  

HINT:

Tape SST before use.



b.

Using SST, fully turn the steering rack right and left 1 to 2 times to settle it.

SST
09616-00011  


c.
C235036E01
2.843,1.066 3.143,1.214 0.301,0.149 10 SST 2.819,1.147 2.208,1.147 false

Using SST and a torque wrench, turn the pinion at a fixed speed between 4 to 6 seconds and check the total turning torque.

SST
09616-00011  

Standard preload:
Tire Size preload
175/70R14
175/65R15
0.57 to 1.17 N*m (5.9 to 11.9 kgf*cm, 5.1 to 10.3 in.*lbf)
175/65R14
185/60R15
0.6 to 1.2 N*m (6.1 to 12.2 kgf*cm, 5.3 to 10.6 in.*lbf)


NOTICE:

Remove the steering rack boot before measurement.


HINT:
·

Inspect around the steering rack center position.

·

If the total preload is not within the specified range, replace the steering gear assembly with a new one.