Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248261 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E231980E01
5.586,2.852 6.597,3.387 1.012,0.536 10 F107 Radio Receiver Assembly 5.37,2.141 5.550,2.327 0.179,0.186 10 7 5.37,0.7 5.550,0.886 0.179,0.186 10 4 5.37,1.421 5.550,1.607 0.179,0.186 10 3 5.594,0.801 6.043,0.956 0.449,0.154 10 +B1 5.594,1.522 6.043,1.676 0.449,0.154 10 ACC1 5.594,2.242 6.043,2.397 0.449,0.154 10 GND1 1.027,0.801 1.838,0.956 0.811,0.154 10 from Battery 0.76,1.522 1.836,1.676 1.076,0.154 10 from ACC Relay 3.359,0.958 3.808,1.113 0.449,0.154 10 DOME 3.419,1.684 3.868,1.839 0.449,0.154 10 ACC

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)
a.
U158652E02
2.208,1.031 2.75,1.396 true 2,0.938 2.75,0.625 true 1.635,1.271 1.635,1.74 true 0.146,0.115 0.333,0.344 0.188,0.229 10 false *a 2.781,1.344 3.229,1.552 0.448,0.208 10 false +B1 2.781,0.521 3.229,0.729 0.448,0.208 10 false ACC1 1.448,1.76 2.073,1.969 0.625,0.208 10 false GND1 1.563,0.344 1.906,0.5 0.344,0.156 10 false F107

Disconnect the F107 radio receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F107-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F107-4 (+B1) - Body ground Always 11 to 14 V
F107-3 (ACC1) - Body ground Ignition switch ACC 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Radio Receiver Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR