Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248261 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly through this circuit.

The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM

E228896E04
0.938,5.073 2.177,6.125 1.24,1.052 10 false F53 No. 1 Stereo Jack Adapter Assembly 5.125,5.073 6.281,5.792 1.156,0.719 10 false Radio Receiver Assembly 2.083,2.917 2.26,3.104 0.177,0.188 10 false 5 2.083,2.417 2.26,2.604 0.177,0.188 10 false 8 2.083,1.438 2.26,1.625 0.177,0.188 10 false 2 2.083,3.406 2.26,3.594 0.177,0.188 10 false 7 2.083,3.885 2.26,4.073 0.177,0.188 10 false 6 2.083,4.396 2.26,4.583 0.177,0.188 10 false 9 2.083,0.938 2.26,1.125 0.177,0.188 10 false 3 5.219,2.5 5.667,2.656 0.448,0.156 10 false ADPG 5.219,3.031 5.667,3.188 0.448,0.156 10 false VAR+ 5.219,4 5.667,4.156 0.448,0.156 10 false VAL+ 5.219,3.49 5.667,3.646 0.448,0.156 10 false VA- 5.219,4.49 5.667,4.646 0.448,0.156 10 false AGND 1.531,2.5 1.979,2.656 0.448,0.156 10 false AUXO 1.604,3 2.052,3.156 0.448,0.156 10 false ARO 1.531,3.479 1.979,3.635 0.448,0.156 10 false ASGN 1.615,3.99 2.063,4.146 0.448,0.156 10 false ALO 1.531,4.49 1.979,4.646 0.448,0.156 10 false AGND 3.271,4.635 4.01,5 0.74,0.365 10 false (Shielded) 3.271,2.135 4.01,2.5 0.74,0.365 10 false (Shielded) 4.854,4.5 5.135,4.656 0.281,0.156 10 false F47 4.906,4.313 5.083,4.5 0.177,0.188 10 false 11 4.854,4.01 5.135,4.167 0.281,0.156 10 false F47 4.906,3.802 5.083,3.99 0.177,0.188 10 false 28 4.854,3.51 5.135,3.667 0.281,0.156 10 false F47 4.906,3.313 5.083,3.5 0.177,0.188 10 false 27 4.854,3.021 5.135,3.177 0.281,0.156 10 false F47 4.906,2.823 5.083,3.01 0.177,0.188 10 false 26 4.854,2.531 5.135,2.688 0.281,0.156 10 false F47 4.906,2.333 5.083,2.521 0.177,0.188 10 false 25 4.948,1.833 5.125,2.021 0.177,0.188 10 false 5 4.948,1.323 5.125,1.51 0.177,0.188 10 false 2 4.823,1.531 5.177,1.688 0.354,0.156 10 false F112 4.823,2.021 5.177,2.177 0.354,0.156 10 false F112 4.823,1.031 5.177,1.188 0.354,0.156 10 false F112 4.948,0.844 5.125,1.031 0.177,0.188 10 false 3

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F47 and F112 radio receiver assembly connectors.


b.

Disconnect the F53 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F47-26 (VAR+) - F53-5 (ARO) Always Below 1 Ω
F47-28 (VAL+) - F53-6 (ALO) Always Below 1 Ω
F47-27 (VA-) - F53-7 (ASGN) Always Below 1 Ω
F47-25 (ADPG) - F53-8 (AUXO) Always Below 1 Ω
F47-11 (AGND) - F53-9 (AGND) Always Below 1 Ω
F112-2 - F53-2 Always Below 1 Ω
F112-3 - F53-3 Always Below 1 Ω
F47-26 (VAR+) - Body ground Always 10 kΩ or higher
F47-28 (VAL+) - Body ground Always 10 kΩ or higher
F47-27 (VA-) - Body ground Always 10 kΩ or higher
F47-25 (ADPG) - Body ground Always 10 kΩ or higher
F47-11 (AGND) - Body ground Always 10 kΩ or higher
F112-2 - Body ground Always 10 kΩ or higher
F112-3 - Body ground Always 10 kΩ or higher
F112-5 - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR