86160
1.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
Check the speaker installation.
The speaker is securely installed.
Visually check the speaker.
The cone paper of the speaker is not torn.
Check the speaker resistance.
| *a | Component without harness connected
(Front No. 1 Speaker Assembly) |
Disconnect the front No. 1 speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | Approximately 4 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.