Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248274 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  CD cannot be Inserted / Played or CD is Ejected Right After Insertion  


PROCEDURE

1.CHECK IF A PROPER CD IS INSERTED
a.

Make sure that the CD is an audio CD or a CD with an MP3 WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

OK:

The CD is normal.


HINT:
·

Translucent or uniquely-shaped CDs cannot be played.

·

CDs with adhesive paper labels should not be played.

·

Commercial audio CDs can be played.

·

CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

MP3, WMA and AAC files on CD-ROMs, CD-Rs and CDRWs can be played.

·

For details on playable CDs, refer to the Owner's Manual.





OK

2.CHECK THAT CD IS INSERTED PROPERLY

NG

CHANGE CD

2.CHECK THAT CD IS INSERTED PROPERLY
a.

Check whether or not the CD is inserted upside down.

OK:

CD is properly inserted.




OK

3.CLEAN CD AND RECHECK

NG

SET CD PROPERLY

3.CLEAN CD AND RECHECK
a.
I100151

Check for dirt on the CD surface.

OK:

Dirt is on the CD surface.


NOTICE:

Do not use a conventional record cleaner or antistatic preservative.


HINT:

If the CD is dirty, clean the CD by wiping the CD surface radially with a soft cloth.




OK

END (CD WAS DIRTY)

NG

4.REPLACE CD AND RECHECK
4.REPLACE CD AND RECHECK
a.

Replace the CD with a normal one and check that the same trouble does not occur.

OK:

Same trouble does not occur.




OK

END (CD WAS DEFECTIVE)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY