Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248274 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Illumination Circuit  


DESCRIPTION

Power is supplied to the radio and display receiver assembly illumination when the light control switch is in the TAIL or HEAD position.

WIRING DIAGRAM

B378027E04
2.896,1.01 3.385,1.188 0.49,0.177 10 false PANEL 0.813,0.823 1.854,1.219 1.042,0.396 10 false from TAIL Relay 4.958,2.042 6.198,2.719 1.24,0.677 10 false Radio and Display Receiver Assembly 5.229,0.802 5.719,0.979 0.49,0.177 10 false ILL+ 4.958,1.875 5.448,2.052 0.49,0.177 10 false F125 4.958,0.74 5.167,0.917 0.208,0.177 10 false 10

CAUTION / NOTICE / HINT

CAUTION:
·

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC/Separate Type Yaw Rate Sensor)>PRECAUTION)

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the radio and display receiver assembly or other parts (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

Result
Result Proceed to
Illumination comes on for all components except radio and display receiver A
No illumination comes on (radio and display receiver, hazard switch, heater control switch, etc.) B



A

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY)

B

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY)
a.
U158703E02
2.385,1.583 2.146,1.375 true 1.552,0.406 1.906,0.563 0.354,0.156 10 false F125 0.146,0.104 0.438,0.26 0.292,0.156 10 false *a 2.448,1.531 2.802,1.688 0.354,0.156 10 false ILL+

Disconnect the radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F125-10 (ILL+) - Body ground Light control switch TAIL or HEAD 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR