Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248274 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E228888E15
5.13,2.881 6.403,3.227 1.273,0.346 10 Radio and Display Receiver Assembly 5.14,2.722 5.497,2.877 0.357,0.154 10 F129 0.941,2.881 2.196,3.245 1.256,0.363 10 No. 1 Stereo Jack Adapter Assembly 2.081,0.974 2.260,1.160 0.179,0.186 10 2 2.081,1.467 2.260,1.653 0.179,0.186 10 3 3.314,2.244 4.057,2.428 0.743,0.184 10 Shielded 4.923,1.961 5.102,2.147 0.179,0.186 10 5 4.923,1.469 5.102,1.654 0.179,0.186 10 3 4.923,0.976 5.102,1.162 0.179,0.186 10 2 0.951,2.722 1.308,2.877 0.357,0.154 10 F53

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F129 radio and display receiver assembly connector.


b.

Disconnect the F53 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F129-2 - F53-2 Always Below 1 Ω
F129-3 - F53-3 Always Below 1 Ω
F129-2 - Body ground Always 10 kΩ or higher
F129-3 - Body ground Always 10 kΩ or higher
F129-5 - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR