These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B158D | The internal video signal stoppage of the radio and display receiver assembly | Radio and display receiver assembly |
| B15A0 | When either condition below is met:
·
Bus malfunction ·
EEPROM error |
|
| B15B0 | Picture circuit (TFT unit) malfunction | |
| B15B3 | When either condition below is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
|
| B15B4 | When either condition below is met:
·
Mechanism drive signal malfunction ·
Load/Eject malfunction ·
Read mechanical malfunction ·
Mechanical malfunction |
|
| B15B7 | "Bluetooth" module malfunction. |
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).
Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG